Cross Break In Sheet Metal

Cross Break In Sheet Metal – To add a cross break to a sheet metal part: Here is a video that shows the basics on the new cross break bends and cut curves (versus bends) in the sketch bend tool. To add a cross break to a sheet metal part: The cross break was easy.

Cross breaks cross breaks are a cost effective method for strengthening a thin piece of sheet metal. Click cross break (sheet metal toolbar) or insert > sheet metal > cross break. A cross break in sheet metal is when multiple obtuse bend angles of approximately 170° are made across a flat section thin metal. Typically, this is done in an x shape, however two lines crossing at most.

Cross Break In Sheet Metal

I was amused to read on this page: The cross break is not a geometric entity and it does not alter the. Solidworks ii sheet metal ii cross break:

The cross break is not a geometric entity and does not alter the. The cross break command lets you insert a graphical representation of a cross break in a sheet metal part. To form, the operator marks the bend line on the sheet as a guide, then lines it up with punch tip and performs a shallow bend.

So we’re going to give this a try, and refine it with the flared hole later, if need be. The cross break command lets you insert a graphical representation of a cross break in a sheet metal part. A cross break in sheet metal is when multiple obtuse bend angles of approximately 170° are made across a flat section thin metal.

Take a look and give it a try in the beta. 300 s pennell rd, suite 100, media, pa 19063. The sheet metal, by the way, is the 11ga i started with.

Solidworks Sheet Metal Design Sketch Bend And Cross Break Command